[. . . ] • Unpack the oven and make sure that the appliance has not been damaged during transport and that the oven door closes properly. • After removing the oven from its packaging, leave it on the polystyrene base to prevent it from being damaged. [. . . ] • When installing the oven it is advisable to wear protective gloves. • Connection to the mains must be carried out by a qualified electrician in accordance with the manufacturer's instructions and in compliance with local regulations. • The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. • The oven power cable must be long enough to connect the built-in appliance to the mains. • Observance of safety directives requires that a multi pole switch with a minimum contact gap of 3 mm be used for the installation. • After the oven has been installed, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. When installation has been completed, the bottom of the oven must be inaccessible. • Ovens that are not equipped with a cooling system cannot be installed in split level units (fig 2). • When installing, make sure that the sides of the oven do not touch the adjacent kitchen units (fig. • When installing ovens under the worktop, leave a minimum clearance of 5 mm between the upper edge of the oven and the lower edge of the worktop (fig. In order for the appliance to operate properly, this clearance must never be obstructed. • If the kitchen unit is not securely fixed to the wall, it must be anchored with standard brackets (G) (fig. [. . . ] • If the kitchen unit is not securely fixed to the wall, it must be anchored with standard brackets (G) (fig. 7) available on the market. ~ ~ H05 RR-F 3 X 1. 5 mm² H05 RR-F 3 X 1. 5 mm² (Switzerland only) Securing the oven • Lift the oven getting hold of it by the openings on the sides and insert it into the housing unit, being careful not to trap the power supply cable (fig. [. . . ]